The trailer balls connect gooseneck trailers to pull vehicles. The trailer balls attach directly to the bed of the vehicle to the bed, just behind the rear axle a little. The trailer ball is removed easily when not used. The vehicle’s bed can be utilized to the fullest extent. The trailer ball should be in compliance with the towing requirements of the vehicle prior to being put in place. The trailer ball is to be used on the vehicle that has been certified for towing. A gooseneck hitch purchase comes with all the necessary hardware. Get a partner to help with installation for a much more easy installation.
You will require an adjustable wrench 3-3/4-inch circular cutter, drill bits for cutting two Jacks, a drill, and drill bits that are able to go through the bed of your vehicle.
1. The circle cutter must first be connected to the drill. As per the instructions from the manufacturer, drill 3-3/4 inch holes in the car’s cargo bed following the directions provided by the maker. It is recommended that the hole be placed between the passenger’s side of the vehicle as well as the driver’s side.
2. Utilize jacks on both the rear ends of the vehicle to help jack it up. The axle shouldn’t be utilized to jack up the vehicle, but the frame is the best option. If there is a spare tire available remove it in order to provide more space to work from. The owner’s manual will give the instructions. The frame rails are located under the vehicle and slide across the crossbar in front. The crossbar holes must face toward the rear. Click here to read about Be Careful Of Emergency Road Services All Year Round.
3. The bolts must be inserted through the hole. The bolt’s threading is facing the ground. The parts list will assist you in determining the right bolts to choose from. The list of parts must be kept handy as it is required for the duration of the installation. This list will allow you to determine which hardware you should use.
4. A friend can help you put the hitch under the vehicle. Be sure that the holes are aligned with the head of the hitch. To secure the head of the hitch the rear crossbar needs to be placed on top of the frame rails. The bolts that are needed for the hitch should be put into the crossbar’s holes. Be sure that the threading of bolts is on the ground.
5. The holes for mounting the hitch head should be aligned to bolts for the crossbar. The bolts with threaded ends are to be inserted through the holes of the head. When you put the hitch in place your friend must be able to hold the head of the hitch in position. A suitable washer must be placed into each bolt’s threaded end. A suitable nut should be placed into each bolt with the adjustable wrench. The nuts must be tightened completely down.
6. The bolt of the trailer ball must be placed in the bed of the vehicle. The trailer ball should be perfectly within the hole. If it does not then two or three spacers need to be attached to the bolts that hold the trailer ball in place and adjusted until the ball is perfectly centered into the hole after the ball is placed.
7. Then follow the trailer hitch’s instructions for installation to drill holes according to the procedure-specific method in the manual. The holes should be made using pre-marked indicators that are placed at the top of the hitch. The holes should be made through the bottom of the hitch head into the bed of the truck. Be sure to drill slowly and certain because the holes are not able to be drilled twice if they are not drilled correctly during your first attempt.
8. The appropriate bolts must be placed into the holes and then the springs are then slid over the bolts. The nuts should be tightened to each bolt’s threaded end in order to anchor the bolts onto the top of the hitch.
9. Attach the proper nuts to the threaded ends of the trailer ball for the complete trailer ball. The connections should be secure and secure to your trailer ball.
These simple steps will assist you in installing the gooseneck trailer ball. The instruction manual is essential. It will ensure that you are following the manufacturer’s specifications. Different hitches come with different specifications.
